Tracker 4WD L4-1.6L VIN 6 (1998)
7. Lower the floor jack.
8. Remove the coil spring from the vehicle.
INSTALLATION PROCEDURE
Important: The bottom (2) of the coil spring has a larger diameter than the top (1). Be sure to install the spring correctly.
1. Install the coil spring to the vehicle (3).
2. Raise the floor jack.
3. Install the stabilizer joint to the control arm. Secure the stabilizer joint with one nut.
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that
application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the
fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or
other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint
clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these
instructions can help you avoid damage to parts and systems.
4. Install the stabilizer joint to the control arm. Secure the stabilizer joint with one nut.
Tighten the stabilizer joint-to-control arm nut to 50 Nm (37 ft. lbs.).
5. Install the control arm to the ball stud. Secure the control arm with three nuts and bolts.
Tighten the ball stud nuts and bolts to 85 Nm (63 ft. lbs.).
6. Remove the floor jack.
7. If the vehicle is equipped with an engine skid plate, install the following components:
^
The engine skid plate
^
The four engine skid plate bolts
