Tracker 4WD L4-1.6L VIN 6 (1998)
-
J 8092 Driver Handle
IMPORTANT: The right and the left side axle shaft oil seals must be installed into the front axle housing at different depths.
The J 37770 is two sided. One side is stamped with the letter R. The other side is stamped with the letter L. The R and L letters ensure correct
installation of the axle shaft oil seals.
If either axle shaft oil seal is installed incorrectly, the seal may leak, A leak may cause damage to the seal and/or the internal components.
1. Use the J 33833 with the J 8092 in order to install the left inner axle shaft bearing (1) into the front axle housing.
2. Install the left inner axle shaft bearing snap ring (1) into the front axle housing.
3. Use the J 37770 with the J 8092 in order to install the left inner axle oil shaft seal (2) into the front axle housing.
4. Install the left inner axle shaft into the front axle housing. Ensure that the snaps ring seats into the differential side gear.
5. Install the left drive axle shaft into the vehicle. Refer to Wheel Drive Shafts Replacement (Left Drive Axle) in Axle Shaft Assembly, Constant
Velocity Type.
6. Lower the vehicle.
Wheel Drive Shafts Replacement (Left Drive Axle)
FRONT AXLE
REMOVAL PROCEDURE