Tracker 4WD L4-1.6L VIN 6 (1998)
8. Remove the four rear axle shaft retaining nuts (2) from the rear axle shaft bearing retainer studs behind the brake backing plate (3).
IMPORTANT: Do not remove the brake backing plate with the rear axle shaft. If this precaution is not observed, inner seal damage may result.
9. Remove the rear axle shaft (2) and the bearing from the rear axle housing using the J 34866 with the J2619-01.
IMPORTANT: The right and left rear axle shafts are different lengths. The right rear axle shaft is 726.5 mm (28.6 inch) in length. The left rear axle
shaft is 683.5 mm (26.9 inch) in length. When removing both axle shafts, ensure they are installed in their respective sides of the rear axle housing.
10. Measure the rear axle shaft length (2). The length should be measured from the differential end of the shaft to the outside edge of the axle shaft
flange (1).