Tracker 4WD L4-1.6L VIN 6 (1998)
11. Install the two bolts to the rear transmission mount (2).
^
Tighten the rear transmission mount bolts to 60 Nm (44 ft. lbs.).
12. Remove the hydraulic jack from underneath the transmission.
13. Install the Three Way Catalytic Converter (TWC) and the muffler/tail assembly to the vehicle.
14. Install the speedometer driven gear case and the ground wire (1) to the extension case (4); secure with one bolt (2).
^
Tighten the speedometer driven gear case retaining bolt to 12 Nm (106 inch lbs.).
15. Install the speedometer cable (3) to the speedometer driven gear case.
16. Install the rear propeller shaft into the vehicle aligning the index marks made during the removal procedure; secure with four bolts and four nuts.
^
Tighten the rear propeller shaft bolts and the nuts to 50 Nm (37 ft. lbs.).
17. Apply the GM P/N 12346005, or equivalent, to the threaded portion of the transmission drain plug.
