Tracker 4WD L4-1.6L VIN 6 (1998)
7. Remove the gearshift lever case plug (11) from the gearshift lever case (1).
8. Remove the gearshift shaft (14) from the gearshift lever case (1) while simultaneously removing the gearshift lever (13), gearshift reverse gearshift
limit yoke (11) and the gearshift limit spring (112) from the gearshift shaft (14).
IMPORTANT: The gearshift lever case contains an inner and outer select return spring on the left side only. The right side contains a single
select return spring. Note the location of these springs to ensure correct assembly.
9. Remove the reverse gearshift limit bolt (16) from the gearshift lever case (1).
10. Remove the following items from the gearshift lever case (1):
^
The two select return spring bolts (2)
^
The three select return springs (3)
^
The two select guide pins (4)
11. Remove the following items from the gearshift lever case (1):
^
The two lever locating bolts (5)
^
The two lever locating washers