Tracker 4WD L4-1.6L VIN 6 (1998)
7. Install the two bolts (2) to the rear transmission mount (1).
^
Tighten the rear transmission mount bolts to 60 Nm (44 ft. lbs.).
8. Remove the hydraulic jack from underneath the transmission.
9. Install the Three-Way Catalytic Converter (TWC) and the muffler/tail pipe assembly to the vehicle.
10. Remove the speedometer driven gear case retaining bolt.
11. Install the ground wire (1) to the speedometer driven gear case by securing with one bolt.
^
Tighten the speedometer driven gear case retaining bolt (2) to 12 Nm (106 inch lbs.).
12. Install the speedometer cable (3) to speedometer driven gear case.
13. Install the rear propeller shaft into the vehicle aligning the index marks made during removal by securing with four bolts and four nuts.
^
Tighten propeller shaft bolts and nuts to50 Nm (37 ft. lbs.).
