Tracker 4WD L4-2.0L VIN C (1999)
Electronic Brake Control Module: Service and Repair
REMOVAL PROCEDURE
NOTICE: To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the
ON position.
1. Turn the ignition switch to the OFF position.
2. Remove the Connector Position Assurance (CPA) (2) from the connector lock tab (1).
3. Push the lock tab down and then move the sliding connector cover (2) to the open position.
4. Disconnect the Electronic Brake Control Module (EBCM) harness connector.
5. Brush off any dirt/debris that has accumulated on the assembly.
6. Remove the four EBCM to Brake Pressure Modulator Valve (BPMV) screws (1).