Tracker 4WD L4-2.0L VIN C (1999)
NOTICE:
^
Do not use a tool to pry the EBCM from the BPMV. Excessive force will damage the EBCM.
^
Be careful not to damage the EBCM seal when removing the EBCM.
7. Separate the EBCM (2) from the BPMV (3) by gently pulling apart until separated.
INSTALLATION PROCEDURE
1. Clean the EBCM gasket and the BPMV surface with alcohol using a clean rag.
2. Install the EBCM (2) to the BPMV (4).
NOTICE: Refer to Fastener Notice in Service Precautions.
3. Install the four screws (1) that attaches the EBCM (2) to BPMV (4).
^
Tighten the four screws to 5 Nm (44 inch lbs.).
4. Connect the EBCM harness connector (2).
5. Push down lock tab and then move sliding connector cover back in the home position to lock.
