Tracker 4WD L4-2.0L VIN C (1999)
7. Connect the following electrical connectors:
^
The intake air temperature (IAT) sensor
^
The mass air flow (MAF) sensor
^
The EVAP tank pressure control solenoid valve
^
The EVAP canister vent solenoid
^
The EVAP canister purge valve
^
The throttle position sensor (TPS) (8)
^
The idle air control (IAC) valve (6)
^
The power steering pressure switch
^
The generator
^
The starter motor
^
The crankshaft position (CKP) sensor
^
The exhaust gas recirculation (EGR) valve (1)
^
The manifold absolute pressure (MAP) sensor (11)
^
G102
^
G103 (10)
^
The noise suppressor filter
^
The engine coolant temperature (ECT) sensor (2)
^
The heated oxygen (HO2S1) sensor
^
The heated oxygen (HO2S2) sensor (California emissions only)
^
The oil pressure switch
^
The camshaft position (CMP) sensor
^
The ignition coils
^
The fuel injector harness, C102 (3)
^
The back up lamp switch
^
The transmission range switch
^
The input shaft speed sensor
^
The 4 wheel drive low switch
^
The 4 wheel drive switch
^
The vehicle speed sensor (VSS)
^
The output shaft speed sensor
^
The torque converter clutch (TCC) solenoid/shift solenoid
