Tracker 4WD L4-2.0L VIN C (1999)
6. Using the J 1859-A in order to remove the steering wheel (1).
INSTALLATION PROCEDURE
1. If you DID replace the steering column, ensure the front wheels and tires did not move.
2. If you DID NOT replace the steering column, ensure the front wheels and tires are aligned in the straight ahead position.
3. If necessary, center the inflatable restraint steering wheel module coil. Refer to Inflatable Restraint Coil Centering - Off Vehicle.
4. If you are replacing the steering wheel, use paint in order to place alignment marks (2) on the new steering wheel in the same position as on the old
steering wheel.
NOTICE: When installing the steering wheel, ensure that the 2 tabs on the SIR coil align with the 2 slots on the steering wheel mounting surface.
Failure to align the tabs may cause incorrect alignment of some components during installation. This may damage the SIR coil.
5. Install the steering wheel (3) to the steering shaft. Fit the 2 tabs on the inflatable restraint steering wheel module coil (5) into the 2 slots in the back
of the steering wheel (4). Align the marks (1) on the steering wheel and on the steering shaft.
