Tracker 4WD L4-2.0L VIN C (1999)
10. Remove the following components from the lower valve body:
^
The 3 bolts
^
The shift solenoid assembly (3)
^
The shift solenoid assembly gasket
^
For a complete schematic of the shift solenoid assembly system, refer to Automatic Transmission Controls Schematics.
Installation Procedure
1. Install the new shift solenoid assembly gasket and the shift solenoid assembly (3) to the lower valve body.
Notice: Refer to Fastener Notice in Service Precautions.
2. Secure the shift solenoid assembly onto the lower valve body with the 3 bolts.
^
Tighten the shift solenoid assembly bolts to 10 Nm (89 inch lbs.).
3. Install the electrical connector to the TCC solenoid.
4. Install the new brake applying cover gasket to the transmission body.
5. Install the brake applying cover onto,the transmission body.
6. Secure the brake applying cover with the 2 bolts.
^
Tighten the brake applying cover bolts to 10 Nm (89 inch lbs.).
7. Apply a thin coat of automatic transmission fluid to the fluid pipe O-rings.
