Tracker 4WD L4-2.0L VIN C (1999)
3. Remove the 4 bolts (1) and the 4 nuts (4) holding the yoke (2). Separate the pinion flange yoke from the differential pinion flange (3).
4. Remove the sliding yoke from the transmission.
5. Remove the rear propeller shaft from the vehicle.
6. Inspect the rear propeller shaft for dents or other damage. Replace the rear propeller shaft if the shaft is damage.
7. Inspect the universal joints for smooth pivoting. If the universal joints bind or appear tight, replace the universal joints as assemblies. Refer to
Universal Joints Replacement.
8. Inspect the sliding yoke splines (1) for excessive wear or damage. If the splines appear worn or rounded, replace the Sliding yoke (3). Refer to
Universal Joints Replacement.
9. Inspect the sliding yoke surfaces for the following:
^
Scoring
^
Burrs
^
Other damage
^
If the sliding yoke surface appears scored or rough, replace the sliding yoke. Refer to Universal Joints Replacement
10. Inspect the pinion flange yoke for the following:
^
Cracks
^
Distortion
^
Other damage
^
If the pinion flange yoke appears damaged or distorted, replace the pinion flange yoke. Refer to Universal Joints Replacement.
Installation Procedure
