Tracker 4WD L4-2.0L VIN C (1999)
59. Install the differential carrier (1) into the front axle housing (2).
60.
Install the 6 differential carrier bolts and the two reamer bolts.
Tighten
Tighten the differential carrier bolts to 23 Nm (17 lb ft).
61.
Install the left side output shaft axle to the differential housing.
62.
Raise the front differential housing with assistants and support with a suitable hydraulic jack.
63.
Install the front differential mount to left mounting bolts.
Tighten
Tighten the bolts to 50 Nm (37 lb ft).
64.
Install the front differential mount to right mounting bolts.
Tighten
Tighten the bolts to 50 Nm (37 lb ft).
65.
Remove the hydraulic jack from supporting the front differential housing.
66.
Install the front differential rear mount and the nuts and bolts.
Tighten
Tighten the front differential rear mount bolts and nuts to 50 Nm (37 lb ft).
67.
Install the front propeller shaft and bolts.
Tighten
Tighten the propeller shaft bolts to 50 Nm (37 lb ft).
68.
Connect the vent hoses.
69.
Install the differential side joint flange of the drive axle shaft to the inner axle shaft flange.
Be sure to align the reference marks on the inner axle shaft flange and the differential side joint flange of the drive axle shaft.
70.
Secure the flange bolts and nuts.
Tighten
Tighten the differential side joint bolts and nuts to 55 Nm (41 lb ft).
71.
Install the new retaining ring and right drive axle shaft to the differential housing.
