Tracker 4WD V6-2.5L VIN 4 (2001)
3. Install the new camshaft cover gasket to the camshaft cover.
4. Install the new cylinder head side seal to the cylinder head.
5. Install the camshaft cover (1) to the cylinder head.
Notice: Refer to Fastener Notice in Service Precautions.
6. Using new seal washers (3), tighten the 4 nuts (2) on the camshaft cover (1).
Tighten the nuts to 10.5 Nm (7.5 ft. lbs.).
7. Install the ignition coils.
8. Connect the ignition couplers.
9. Install the ignition coil cover.
10. Install the throttle body and intake manifold.