TrailBlazer 2WD V8-5.3L (2007)
Tighten the anchor bolt to 70 N.m (52 lb ft).
6. Install the left rear door sill panel.
7. Install the liftgate sill plate.
8. Install the left body side upper trim panel.
Rear Quarter Trim Panel Replacement - Right Side
Rear Quarter Trim Panel Replacement - Right Side
Removal Procedure
1. Remove the cargo shade/cover.
2. Remove the inflator access panel.
3. Remove the right rear quarter upper trim panel.
4. Remove the lift gate sill plate.
5. Remove the right rear door sill panel.
6. Remove the lower seat belt anchor bolt.
7. Release the retaining clips that retain the trim panel to the body.
8. Partially remove the trim panel in order to remove the inflator switch from the inflator bezel.
9. Remove the auxiliary air outlet washer and retaining nut.
10. Feed the auxiliary air outlet through the inflator bezel.
11. Remove the inflator bezel from the trim panel.
12. Disconnect the 12-volt power supply electrical connector.
13. Remove the trim panel from the vehicle.
Installation Procedure
1. Position the trim panel to the vehicle.
2. Connect the 12-volt power supply electrical connector.
3. Install the inflator bezel to the trim panel.
4. Feed the auxiliary air outlet through the hole in the inflator bezel.
Notice: Refer to Fastener Notice.
