TrailBlazer 2WD V8-5.3L (2007)
5. Install the auxiliary air outlet washer and retaining nut.
Tighten the nut to 2 N.m (18 lb in).
6. Install the inflator switch to the inflator bezel.
7. Position the seat belt over the top of the trim panel, ensuring that the buckle is not behind the trim panel.
8. Align the locating tabs on the trim panel to the holes in the body.
9. Seat the clips that retain the trim panel to the body.
10. Install the seat belt lower anchor.
Tighten the anchor bolt to 70 N.m (52 lb ft).
11. Install the right rear door sill panel.
12. Install the lift gate sill plate.
13. Install the trim panel-rear quarter upper.
Rear Quarter Upper Trim Panel Replacement (TrailBlazer, Envoy)
Rear Quarter Upper Trim Panel Replacement (TrailBlazer, Envoy)
Removal Procedure
1. Remove the cargo shade/cover.
2. Remove the screw that retains the trim panel to the body.
3. Remove the cargo net retaining knobs.
4. Remove the bolt that retains the seat belt upper guide to the body.
5. Remove the rear upper quarter trim panel from the vehicle.
Installation Procedure
1. Install the rear upper quarter trim panel to the vehicle.
2. Install the seat belt retractor to the body.
Notice: Refer to Fastener Notice.
