Traverse FWD V6-3.6L (2009)
Important
Be sure to enlarge on the proper side of the cutout.
2. Enlarge the cutout in the mat (maximum 3-4 mm (0.12-0.16 in)) to allow the retainer to shift the amount necessary to better align to the post
spacing in the carpet. In some cases, all retainers may need to be enlarged.
3. Reassemble the retainer to the mat. Prior to pressing the two halves of the retainer together, apply a thin coat of Instant Gel Adhesive, P/N
12345632 (in Canada, use 10953475) or equivalent, to the inside flange of the lower piece. This will secure the retainer to the backside of the mat
and prevent movement of the retainer.
Warranty Information
For vehicles repaired under warranty, use the table above.
Disclaimer
