Traverse FWD V6-3.6L (2009)
1. Loosely Install the air cleaner outlet duct then install the fuel injector sight shield to ensure proper clearance.
2. Remove the fuel injector sight shield.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Tighten the air cleaner outlet duct clamps (1) to 4 Nm (35 lb in) at the MAF/IAT sensor and throttle body.
4. Connect the PCV quick disconnect (2). Refer to Plastic Collar Quick Connect Fitting Service (See: Fuel Delivery and Air Induction/Fuel Line
Coupler/Service and Repair/Plastic Collar Quick Connect Fitting Service).
5. Connect the PCV fresh air tube to the camshaft cover fitting (1).
6. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (See: Fuel Delivery and Air Induction/Fuel Injector/Service
and Repair/Fuel Injector Sight Shield Replacement).
