Traverse FWD V6-3.6L (2009)
2. Install the battery positive junction block cable terminal (4) to the stud.
3. Install the positive battery cable terminal (3) to the junction block stud.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
4. Install the accessory wiring junction block nut (2).
Tighten the nut to 22 Nm (16 lb ft).
5. Close the accessory wiring junction block cover (1).
6. Install the battery positive junction block cable clips (1) to the power steering reservoir bracket.