Traverse FWD V6-3.6L (2009)
7. Install the battery positive junction block cable terminal (3) to the generator stud.
8. Install the battery positive junction block cable to generator nut (3).
Tighten the nut to 22 Nm (16 lb ft).
9. Position the battery positive junction block cable boot (1).
10. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
11. Install the battery positive junction block cable terminal (2) to the starter.
12. Install the starter solenoid BAT terminal nut (3).
Tighten the nut to 25 Nm (18 lb ft).
13. Install the battery positive junction block cable clip (1) to the engine block.
