W 3500 L4-5.2L DSL Turbo (2005)
5. Ensure that ALL programming contents are entered correctly and were programmed successfully by turning OFF the ignition for 30 seconds.
6. Using the scan tool to check each programmed fuel injector flow rate following this navigation: Diagnostics > (5) 2005 > Isuzu > NPR/NQR/NRR
> F0: Powertrain > (6) 5.2L L4 Diesel > Automatic or Manual > F2: Special Functions > F5: Option Programming > F0: Injector Flow Rates.
7. Start the engine and let idle.
8. Inspect for a proper engine running condition and for no DTCs. Refer to the Diagnostic System Check - Engine Control if needed.
Option Programming Procedure
Refer to each procedure in this section.
-
Power Take Off (PTO) Options (if equipped)
-
Cruise Control Options
-
Exhaust Brake Options
-
Vehicle Speed Limit Option
