300 V6-3.5L (2008)
6. Disconnect primary (3) and secondary (2) brake tubes from master cylinder (4). Install sealing plugs in open brake tube outlet ports.
CAUTION: Before removing master cylinder from power brake vacuum booster, master cylinder and vacuum booster must be thoroughly
cleaned. This must be done to prevent dirt particles from falling into power brake vacuum booster. Use only Mopar(R) Brake Parts Cleaner or
equivalent.
7. Remove two nuts (2) attaching master cylinder (3) to power brake booster (1).
8. Slide master cylinder (3) straight out of power brake booster (1).
CAUTION: Vacuum seal (1) on rear of master cylinder (2) is used to allow vacuum ability in power brake vacuum booster. Vacuum seal MUST
be replaced whenever master cylinder is removed from power brake vacuum booster.
9. Remove vacuum seal (1) located on mounting flange of master cylinder (2). Vacuum seal is removed by carefully pulling it off rear of master
cylinder. Do not attempt to pry seal off master cylinder by inserting a sharp tool between seal and master cylinder casting. Damage can