300 V6-3.5L (2008)
occur.
Master Cylinder - Installation
MASTER CYLINDER
1. Thoroughly bleed master cylinder before installing it on vehicle. See: Procedures
CAUTION: When replacing master cylinder on vehicle, a NEW vacuum seal (1) MUST be installed on master cylinder.
2. Install NEW vacuum seal (1) on rear of master cylinder (2) making sure seal fits squarely in mounting groove.
3. Position master cylinder (3) on studs of power brake booster, aligning booster push rod with master cylinder piston.
4. Install two master cylinder mounting nuts (2). Tighten mounting nuts to 15 Nm (133 in. lbs.).