300 V6-3.5L (2008)
7. Connect the electrical connector to EGR valve and lock.
8. Verify that no wiring harnesses or hoses are contacting the EGR tube.
9. Install upper intake manifold, See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and Repair/Intake Manifold - Installation.
NOTE: Install new rubber silicone seals on intake manifold end of EGR tube any time it is removed from the intake manifold.
10. Verify the upper EGR tube seal (1) is positioned correctly on the EGR tube assembly.
NOTE: The EGR tube flange does not need to be flush with the intake manifold to be sealed. The EGR tube flange can be up to 2mm from
intake manifold and still be sealed. This design allows the EGR tube position to vary with the tolerance stack up and remain properly sealed.
11. Install the EGR tube (3), and verify the seal is correctly positioned in the intake manifold.