300 SRT-8 V8-6.1L VIN W (2005)
PARTS REQUIRED:
REPAIR PROCEDURE:
1.
Open the trunk lid.
2.
Pull the trunk carpet away from one side of the trunk.
3.
Remove the push pin (located above and rearward of the body exhauster) attaching the fascia to the body side, by pushing out the center (white)
pin with a punch, then push (black) body through hole, (Fig. 2). Pin and body will fall to the ground under the rear fascia.
Disclaimer:
This bulletin is supplied as technical information only and is not an authorization for repair.