Service and Repair Procedures for Interior Moulding Trim Panel in 2005 300 SRT-8 V8-61L VIN W
1. Using a trim stick or another suitable wide flat-bladed tool, carefully pry the upper end of the A-pillar trim (1) rearward from the inside of the
A-pillar (3) far enough to disengage the two spring clip retainers that secure the trim to the slots in the pillar.
2. Disengage the base of the A-pillar trim from the end of the instrument panel top cover.
3. Remove the A-pillar trim from the vehicle.
INSTALLATION
1. Check to be certain that the energy absorbing cartridge (1) is properly installed and in good condition on the inside of the A-pillar (2). Replace the
cartridge if any damage is evident. Tighten the screws (3) to 3 N.m (25 in.lbs.).