300 SRT-8 V8-6.1L VIN W (2005)
5. Disconnect wiring harness (6) connector from brake fluid level sensor (2) in master cylinder brake fluid reservoir (1).
6. If equipped with Electronic Stability Program, disconnect wiring harness (6) connector from pressure switch (5).
7. Disconnect primary (3) and secondary (2) brake tubes from master cylinder (4). Install sealing plugs in open brake tube outlet ports.
CAUTION: Before removing master cylinder from power brake vacuum booster, master cylinder and vacuum booster must be thoroughly cleaned.
This must be done to prevent dirt particles from failing into power brake vacuum booster. Use only Mopar(R) Brake Parts Cleaner or equivalent.
8. Remove two nuts (1) attaching master cylinder to power brake booster.
9. Slide master cylinder straight out of power brake booster.
CAUTION: Seal on rear of master cylinder (2) is used to allow vacuum ability in power brake vacuum booster. Vacuum seal on master cylinder