300 SRT-8 V8-6.1L VIN W (2005)
MUST be replaced whenever master cylinder is removed from power brake vacuum booster.
10. Remove vacuum seal located on mounting flange of master cylinder (2). Vacuum seal is removed by carefully pulling it off rear of master cylinder.
Do not attempt to pry seal off master cylinder by inserting a sharp tool between seal and master cylinder casting. Damage can occur.
DISASSEMBLY
1. Clean master cylinder housing and brake fluid reservoir. Use only Mopar(R) Brake Parts Cleaner or equivalent.
2. If equipped with Electronic Stability Program, remove pressure switch on bottom of master cylinder (1).
3. Remove brake fluid reservoir cap (1). Using a syringe or equivalent type tool, empty as much brake fluid as possible from the reservoir.
CAUTION: When removing fluid reservoir from the master cylinder, do not pry off using any type of tool. This can damage the fluid reservoir or
master cylinder housing.
4. Remove screw (3) fastening fluid reservoir to master cylinder housing.
5. Rock the brake fluid reservoir side-to-side while pulling up to remove it from seal grommets in master cylinder housing.