300 SRT-8 V8-6.1L VIN W (2005)
4. If equipped with Electronic Stability Program, install pressure switch (1) on bottom of master cylinder. Tighten switch to 28 Nm (250 inch lbs.)
torque.
5. Thoroughly bleed master cylinder before installing it on vehicle.
6. Install master cylinder on power brake booster. Upon installation, vacuum seal (2) on rear of master cylinder must be replaced.
INSTALLATION
1. Thoroughly bleed master cylinder before installing it on vehicle.
CAUTION: When replacing master cylinder on vehicle, a NEW vacuum seal (2) MUST be installed on master cylinder.
2. Install NEW vacuum seal (2) on rear of master cylinder making sure seal fits squarely in mounting groove.