300 SRT-8 V8-6.1L VIN W (2005)
3. Position master cylinder (4) on studs of power brake booster, aligning booster push rod with master cylinder piston.
4. Install two master cylinder mounting nuts (1). Tighten both mounting nuts to 25 Nm (225 inch lbs.) torque.
CAUTION: When tightening primary and secondary brake tube nuts at master cylinder, be sure brake tubes do not contact any other components
within vehicle and that there is slack in flexible sections of tubes. This is required due to movement between ABS ICU and master cylinder while
vehicle is in motion.
5. Thread primary (3) and secondary (2) brake tubes into master cylinder primary and secondary ports. Tighten tube nuts to 14 Nm (124 inch lbs.)
torque.
6. If equipped with Electronic Stability Program, connect wiring harness (6) connector to pressure switch (5).
7. Connect wiring harness (6) connector to brake fluid level switch (2) mounted in brake fluid reservoir (1).
8. Connect battery negative cable (2) to battery post. It is important that this is performed properly.