300 SRT-8 V8-6.1L VIN W (2005)
7. Remove spark plug cable tray from engine by releasing 4 retaining clips (2). Remove tray and cables from engine as an assembly.
8. Disconnect electrical connectors at all 8 ignition coils. Refer to Ignition Coil Removal/Installation.
9. Disconnect fuel line latch clip and fuel line at fuel rail. A special tool will be necessary for fuel line disconnection.
10. Disconnect electrical connectors at all 8 fuel injectors. Refer to graphic. Push red colored slider away from injector (1). While pushing slider,
depress tab (2) and remove connector (3) from injector. The factory fuel injection wiring harness is numerically tagged (INJ 1, INJ 2, etc.) for
injector position identification. If harness is not tagged, note wiring location before removal.
11. Disconnect electrical connectors at all throttle body sensors.