300 SRT-8 V8-6.1L VIN W (2005)
12. Remove four fuel rail mounting bolts (2) and hold-own clamps.
13. Gently rock and pull left side of fuel rail until fuel injectors just start to clear machined holes in intake manifold. Gently rock and pull right side of
rail until injectors just start to clear intake manifold head holes. Repeat this procedure (left/right) until all injectors have cleared machined holes.
14. Remove fuel rail (with injectors attached) from engine.
15. If fuel injectors are to be removed, refer to Fuel Injector Removal/Installation.
INSTALLATION
1. If fuel injectors are to be installed, refer to Fuel Injector Removal/Installation.
2. Clean out fuel injector machined bores in intake manifold.
3. Apply a small amount of engine oil to each fuel injector O-ring. This will help in fuel rail installation.
4. Position fuel rail/fuel injector assembly to machined injector openings in intake manifold.
5. Guide each injector into intake manifold. Be careful not to tear injector O-rings.
6. Push right side of fuel rail down until fuel injectors have bottomed on shoulders. Push left fuel rail down until injectors have bottomed on
shoulders.
7. Install 4 fuel rail holddown clamps and 4 mounting bolts (2) and (3). Refer to Torque Specifications.