300 SRT-8 V8-6.1L VIN W (2005)
43. Check to make sure rear wheels will not rotate with lever applied.
44. Lower vehicle.
45. Connect battery negative cable (2) to battery post. It is important that this is performed properly.
46. Pump brake pedal several times to ensure vehicle has a firm brake pedal before moving vehicle.
47. Position vehicle on alignment rack/drive-on lift. Raise vehicle as necessary to access mounting bolts.
48. Tighten shock absorber lower mounting bolt nuts (4) to 72 N.m (53 ft.lbs.).
49. Perform wheel alignment, paying special attention to thrust angle. If rear crossmember needs to be shifted to align thrust angle, try to avoid
compromising tension link clearance (Refer to Step 22).