300 SRT-8 V8-6.1L VIN W (2005)
Rear Cross-Member Bushing: Service and Repair
Rear Crossmember Bushing - Spring Link
BUSHING-REAR CROSSMEMBER SPRING LINK
REMOVAL
1. Raise and support vehicle.
2. Access and remove rear spring on side of repair.
3. Export Only - If servicing right side bushing, disconnect headlamp leveling sensor (1) link at spring link (3).
4. Remove bolt and nut (1) fastening spring link (4) to crossmember.
5. Position spring link downward, away from bushing in crossmember.
NOTE: Prior to using Press (3), Special Tool C-4212F, lubricate screw-drive threads to provide ease of use and promote tool longevity.