300 SRT-8 V8-6.1L VIN W (2005)
3. Remove fill plug (1) to check and adjust rear axle fluid level. Top off axle with Mopar Gear and Axle Lubricant 75W-140. Reinstall fill plug and
torque to 50 Nm (37 ft. lbs.) torque.
Seal - Pinion Flange
SEAL-PINION FLANGE
REMOVAL
1. Remove rear axle assembly from vehicle. Refer to Rear Axle Removal.
2. Measure axle assembly rotating torque and record measurement for reuse on assembly.
3. Using flange holder C-3281(l) and 41mm socket, remove pinion flange nut and discard.
NOTE: Due to axle imbalance concerns, it is necessary to make sure pinion flange-to-shaft orientation is maintained. If alignment marks are not