Concorde V6-2.7L VIN V (2001)
into the seal groove on that end of sleeve. Install the other end bushing boot into the groove on that end of the bushing sleeve.
Fig 8 Installed Caliper Bushing Sleeve
7. Verify both ends of the bushing are seated in the sleeve groves. When the sleeve is seated properly into the bushing, the sleeve/bushing can be held
between your fingers and easily slid back and forth without the bushing unseating from the sleeve groove.
ASSEMBLY - CALIPER PISTON AND SEAL
Installing New Piston Seal In Caliper
NOTE: Never use an old piston seal.
1. Dip the new piston seal in clean brake fluid and install it in the groove of the caliper bore. The seal should be started at one area of the groove and
gently worked around and into the groove using only your clean fingers to seat it.
2. Coat the new piston boot with clean brake fluid leaving a generous amount inside the boot.
3. Position the dust boot over the piston after coating it with brake fluid.