Concorde V6-2.7L VIN V (2001)
Installing Piston Into Caliper Bore
CAUTION: Force applied to the piston to seat it in the bore must be applied uniformly to avoid cocking and binding of the piston.
4. Install piston into caliper bore pushing it past the piston seal until it bottoms in the caliper bore.
5. Position the dust boot into the counterbore of the caliper assembly piston bore.
6. Using a hammer and Installer, Special Tool C-4689, and Handle, Special Tool C-4171, drive the boot into the counterbore of the caliper.
7. Install the brake shoes.
8. Reinstall the caliper on the vehicle and bleed the brakes as necessary. Refer to Installation.
Rear Disc Brake Caliper
DISASSEMBLY - CALIPER GUIDE PIN BUSHINGS
Before disassembling the brake caliper, clean and inspect it.