Concorde V6-2.7L VIN V (2001)
5. Install the guide pin sleeve into one end of bushing until the seal area of bushing is past the seal groove in the sleeve.
6. Holding the convoluted boot on the opposite end of the bushing, push the steel sleeve through the bushing until the bushing boot is fully seated
into the seal groove on that end of sleeve. Install the other end bushing boot into the groove on that end of the bushing sleeve.
Fig 8 Installed Caliper Bushing Sleeve
7. Verify both ends of the bushing are seated in the sleeve groves. When the sleeve is seated properly into the bushing, the sleeve/bushing can be held
between your fingers and easily slid back and forth without the bushing unseating from the sleeve groove.
