Concorde V6-2.7L VIN V (2001)
6. Tighten the remaining junction block bracket-to-engine cradle crossmember mounting bolt to 26 Nm (230 inch lbs.) torque.
7. Install the four chassis brake tubes (going to each brake) to the junction block. Tighten the tube fittings to 17 Nm (145 inch lbs.) torque with the
aid of a crow foot wrench.
8. Install the two brake tubes coming from the primary and secondary master cylinder ports to the top rear corners of the junction block. Tighten the
tube fittings to 17 Nm (145 inch lbs.) torque with the aid of a crow foot wrench.
9. Install the transmission control module (with speed control servo attached) in its normal position. Install the nut and screw securing it in place
10. Install the transmission control module mounting nut and screw securing it in place. Tighten the screw to 6 Nm (45 inch lbs.). Tighten the nut to
12 Nm (107 inch lbs.) torque.
11. Install the screw attaching the washer filler tube to the upper radiator closure panel.
12. Install the screw attaching the speed control servo to the upper radiator closure panel.
13. Remove the brake pedal holding tool.
14. Bleed the base brake system.