Concorde V6-2.7L VIN V (2001)
mounting surface.
NOTE: Wheel mounting nuts must be installed on the studs as shown to allow proper installation of the wheel cover.
2. Using the valve stem as an index placed at the 12 O'clock position, install and lightly tighten two wheel mounting nuts on the studs located at the 2
O'clock and 10 O'clock positions as shown.
3. Place the wheel cover on the wheel in the following fashion:
a. Align the valve notch in the wheel cover with the valve stem on the wheel.
b. At the same time, align the two holes in the wheel cover having the retaining tabs with the two installed wheel nuts.
c. Press in on center of wheel cover until wheel cover retaining tabs push past and engage rear of previously installed wheel mounting nuts. This
will hold the wheel cover in place.
4. Install and lightly tighten the three remaining wheel mounting nuts, securing the wheel cover in place.
