Concorde V6-2.7L VIN V (2001)
Fig. 8 EGR Tube
The EGR tube attaches to the intake manifold plenum on both sides of the throttle body and the EGR valve.
1. inspect rubber silicone seals on intake manifold end of EGR tube.
2. Install upper tube into the intake manifold, being careful that the silicone rubber seals are correctly installed and undamaged..
3. Install new gasket between the EGR valve and tube and install bolts.
4. Tighten the EGR upper tube to intake manifold plenum screws to 11 Nm (95 in. lbs.) torque.
5. Tighten the EGR upper tube to EGR valve bolts to 11 Nm (95 in. lbs.) torque.
6. Install the throttle cable bracket to intake manifold.
7. Install air inlet tube and resonator.
8. Connect negative battery cable.
LOWER TUBE
REMOVAL
1. Disconnect negative battery cable.
2. Remove air inlet tube and resonator and bracket.
Fig. 3 EGR Tube at Intake Manifold
3. Remove EGR tube mounting screws at EGR valve.
4. Remove EGR tube mounting screws at exhaust manifold.