Concorde V6-2.7L VIN V (2001)
7. Remove lower control arm and tension strut from the cradle as an assembly. Remove them from cradle by first removing pivot bushing end from
cradle and then sliding tension strut out of isolator bushing.
8. Remove tension strut to control arm retaining nut and washer from end of tension strut. While removing nut, keep strut from turning by holding
tension strut at flat using an open end wrench. Discard the retaining nut. A NEW nut must be used when installing tension strut.
9. Separate the tension strut from the lower control arm.
DISASSEMBLY-LOWER CONTROL ARM (PIVOT BUSHING)
1. Remove lower control arm and tension strut as an assembly from the vehicle.
2. Separate the tension strut from the lower control arm assembly.
