Concorde V6-2.7L VIN V (2001)
3. Position lower control arm in arbor press with large end of pivot bushing inside Receiver, Special Tool MB-990799, as shown. Position Remover,
Special Tool 6644-2, on top of pivot bushing.
4. Using the arbor press, press the lower control arm pivot bushing out of lower control arm.
5. Remove the pressed out lower control arm pivot bushing from the Receiver and discard.
DISASSEMBLY-LOWER CONTROL ARM (TENSION STRUT BUSHING)
1. Remove lower control arm and tension strut as an assembly from the vehicle.
2. Separate the tension strut from the lower control arm assembly.
3. Position lower control arm in arbor press with tension strut bushing inside Receiver, Special Tool MB-990799, as shown. Position Remover,
Special Tool 6644-4, on top of tension strut bushing.
4. Lower the arbor press ram, pressing Remover, Special Tool 6644-4, down through the tension strut bushing until the arbor press can push it no
farther. This action will cut the bushing into two pieces.
5. Remove lower control arm from arbor press. Remove pieces of tension strut and Remover, Special Tool 6644-4, from lower control arm.
ASSEMBLY-LOWER CONTROL ARM (PIVOT BUSHING)
