Crossfire V6-3.2L VIN L (2004)
Fluid - A/T: Testing and Inspection
Standard Procedures
STANDARD PROCEDURE - CHECK OIL LEVEL
1. Verify that the vehicle is parked on a level surface.
2. Remove locking pin (1). Remove the plate of the locking pin with a suitable tool and press out the pin remaining in the cap downwards.
3. Remove the cap (2) from the fill tube (3).
WARNING: RISK OF ACCIDENT FROM VEHICLE STARTING OFF BY ITSELF WHEN ENGINE RUNNING. RISK OF INJURY
FROM CONTUSIONS AND BURNS IF YOU INSERT YOUR HANDS INTO THE ENGINE WHEN IT IS STARTED OR WHEN IT IS
RUNNING. SECURE VEHICLE TO PREVENT IT FROM MOVING OFF BY ITSELF. WEAR PROPERLY FASTENED AND
CLOSE-FITTING WORK CLOTHES. DO NOT TOUCH HOT OR ROTATING PARTS.
4. Actuate the parking brake. Start engine and let it run at idle speed in selector lever position "P".
5. Shift through the transmission modes several times with the vehicle stationary and the engine idling
6. Warm up the transmission, wait at least 2 minutes and check the oil level with the engine running. Push the Special Tool 8863A (1) in up to the
stop and pull out again, read off oil level, repeat if necessary.
7. Check the transmission oil temperature.
Note: The true transmission oil temperature can only be read by a scan tool in REVERSE or any forward gear position.
