Pacifica V6-3.8L (2008)
3. Install shoe actuator on end of parking brake cable between parking brake shoes.
4. Install parking brake shoes on support. See: Parking Brake Shoe/Service and Repair/Installation
5. Install bolt (2) securing parking brake cable to knuckle. Tighten bolt to 28 Nm (21 ft. lbs.).
6. Install hub and bearing with wheel speed sensor as well as all components necessary to access it. See: Maintenance/Wheels and Tires/Wheel
Bearing/Service and Repair/Rear Hub / Bearing - Installation
7. While holding cable connector on end of front cable (5) secure with a pair of pliers at the front cable button, Place right rear cable button (4) into
cable connector. Release cables allowing button to seat. It may take some hand pressure to completely seat button.
8. Place left rear parking brake cable button (2) into equalizer (10). Release cables allowing button to seat. It may take some hand pressure to
completely seat button.
9. Lower vehicle.
10. Unlock automatic adjuster in parking brake lever. See: Service and Repair
11. Adjust parking brake shoes as necessary. See: Parking Brake Shoe/Adjustments