Pacifica V6-3.8L VIN L (2005)
Alarm System Transponder: Description and Operation
The Sentry Key Immobilizer System (SKIS) uses a transponder chip that is integral to each ignition key to communicate with the Sentry Key Remote
Entry Module (SKREEM). Ignition keys are supplied with the vehicle when it is shipped from the factory.
Each Sentry Key has a unique transponder identification code permanently programmed into it by the manufacturer. Likewise, the SKREEM has a
unique "Secret Key" code programmed into it by the manufacturer as well. When a Sentry Key is programmed into the memory of the SKREEM, the
SKREEM stores the transponder identification code from the Sentry Key, and the Sentry Key learns the "Secret Key" code from the SKREEM. Once the
Sentry Key learns the "Secret Key" code of the SKREEM, it is also permanently programmed into the transponder's memory. Therefore, blank keys for
the SKIS must be programmed by the SKREEM in addition to being cut to match the mechanical coding of the ignition lock cylinder.
The Sentry Key's transponder is within the range of the SKREEM's transceiver antenna ring when it is inserted into the ignition lock cylinder. When the
ignition switch is turned to the ON position, the SKREEM communicates with the Sentry Key via a radio frequency (RF) signal. The SKREEM
determines if a valid key is present based on the information it receives from the Sentry Key. If a valid key is detected, that fact is communicated to the
PCM via the PCI bus and the vehicle is allowed to continue running. If an invalid key is received by the PCM or no status at all is communicated, the
vehicle will stall after two (2) seconds of running. The indicator light will be flashing at this point. The Sentry Key's transponder can not be repaired. If
it is faulty or damaged, it must be replaced.
Common communication problems:
-
Two transponder keys too close together.
-
Speed Pass too close to transponder key. Solid indicator that there is a system failure.
-
Loss of PCM communication.
-
Failed antenna circuit.