Pacifica V6-3.8L VIN L (2005)
Amplifier: Service and Repair
Base
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Fold the left rear seat flat.
3. Lift up the door covering the jack and amplifier.
4. Remove the mounting fasteners.
Amplifier - Base
5. Disconnect the electrical harness connectors and remove amplifier.
INSTALLATION
1. Connect electrical harness connectors and position amplifier.
2. Install and tighten mounting fasteners.
3. Close door covering jack and amplifier.
4. Raise seat into position.
5. Connect battery negative cable.