Pacifica V6-3.8L VIN L (2005)
Rear Bumper Reinforcement: Service and Repair
Rear Bumper Reinforcement
REAR BUMPER REINFORCEMENT
REMOVAL
1. Remove rear bumper fascia.
2. Support rear bumper reinforcement on a suitable lifting device.
Fig. 11
3. Remove the six nuts attaching rear bumper reinforcement to frame rail extensions (Fig. 11).
4. Remove rear bumper reinforcement from vehicle.
INSTALLATION
1. Support rear bumper reinforcement using a suitable lifting device to lift into position.
2. Position rear bumper reinforcement on vehicle.
3. Install the six nuts attaching rear bumper reinforcement to frame rail extensions and tighten to 27 N.m (20 ft.lbs.) torque (Fig. 11).
4. Install rear bumper fascia.