Pacifica V6-3.8L VIN L (2005)
Fig. 60
19. Remove both front and rear crossmember mounting bolts on left side of vehicle (Fig. 60).
CAUTION: To avoid damaging other components of vehicle, do not lower crossmember any further than necessary to remove coil
spring.
20. Slowly lower jack allowing left side of crossmember to drop. Do not lower jack at a fast rate. Lower jack just enough to allow spring removal. Do
not lower jack any further than necessary.
Fig. 61
21. Remove coil spring and isolator (Fig. 61), lower end first.
22. Raise left side of crossmember back into mounted position and install previously removed mounting bolts. It is not necessary to tighten bolts at
this point.
23. Remove both front and rear crossmember mounting bolts on right side of vehicle (Fig. 60).
CAUTION: To avoid damaging other components of vehicle, do not lower crossmember any further than necessary to remove coil
spring.