Pacifica V6-3.8L VIN L (2005)
24. Slowly lower jack allowing right side of crossmember to drop. Do not lower jack at a fast rate. Lower jack just enough to allow spring removal.
Do not lower jack any further than necessary.
25. Remove coil spring and isolator (Fig. 61), lower end first.
26. Raise right side of crossmember back into mounted position. It is not necessary to install mounting bolts.
27. Remove both front and rear crossmember mounting bolts previously removed on left side of crossmember (Fig. 60).
28. Slowly lower jack. Do not lower jack at a fast rate. As jack is lowered, remove propeller shaft from alignment pin on end of rear driveline module
input flange and support it with a bungee or cord, keeping it at its normal height. Do not allow propeller shaft to hang on its own.
29. Continue to lower jack until rear suspension module is at a comfortable working level.
30. Remove rear suspension module from jack.
31. Turn rear suspension module upside down and place on appropriate working surface.
Fig. 88
32. As an installation reference, carefully mark location of bushing requiring removal on crossmember using a marker or crayon (Fig. 58) and (Fig.
88). Do not use a scratch awl to mark location.
Fig. 89
33. Using a mallet, remove bushing ear by tapping it upward off bushing (Fig. 89).